Corning temperature controller manual

(with External Temperature Controller,Corning Catalog NoPR) PCD, PCD, PCD, PCD, and PR 1 Connect the External Temperature Controller to the connector on the back of the unit.-Temperature Probe in Use Indicator: This will illuminate when External Temperature Controller is properly connected. PDF Content Summary: Instruction Manual For All Hot Plates, Stirrers, and Stirrer/Hot Plates with Digital Displays and for the PR Temperature Controller Catalog Number Model Product Top Plate Volt Volt Number Type Size Volt Volt (Non-Europe) (Europe) PCD Hot Plate 5" x 7" D D D D ( x cm) PC . Dow Corning ® SMS Building Sealant 6. Dow Corning ® Silicone Weatherproofing Sealant 7 Cleaners and Primers 7. Dow Corning ® R Cleaner 7. Dow Corning ® R Cleaner Plus 7. Dow Corning ® 3in1 Primer 7. Dow Corning ® Cleaning Solvent Concentrated Thermal Removal 7. Dow Corning ®.

Pipet Controller Instruction Manual Catalog Number: • The pipet controller may work in temperature range from +10°C to +35°C. The pipet controller is suitable for general laboratory use only. It must be used only by 8 - Corning Stripettor Ultra Pipet Controller 6. Troubleshooting. Hot Plates and Stirrer/Hot Plates (PC and PC Series Only) include a socket for an optional temperature controller () for ability to control samples between 77°F and °F (25°C. The Corning LSE Digital Water Bath is a personal-sized bath constructed from corrosion resistant stainless steel. The seamless chamber can accommodate up to 6 liters of water or can serve as a dry bath when using thermal beads. Temperature can be set from between ambient +5°C and 99°C and easily monitored on the digital display. A stainless steel gable cover is also included, which helps.

8 – Corning Stripettor Ultra Pipet Controller 6. Troubleshooting If during your work the pipet controller is not functioning correctly, check the cause and correct the fault. Problem Possible Cause Action The pipet falls out (the holding force of the pipet is too small), or tilts to the side too much. The pipet holder (Figure 1G) is dirty or wet. Press the MODE button until the “Seal Temp” text is flashing. Use the control knob to adjust the display to the desired temperature. Press the Control knob or wait 10 seconds to set the selected temperature. When a temperature is set above the current temperature of the heating platen, the display will show “Heating”. This manual is designed to assist you in optimal usage of your new hot plate, stirrer, stirrer/hot plate or temperature controller. The manual is available in English, French, German, Japanese, Korean, Mandarin Chinese and Spanish in the product literature section of Corning’s website www.doorway.ru Product Voltages.